Due to its unique design structure and high production efficiency, the circular loom does not require pre-spinning preparation for warping and weft winding processes, and can be woven directly by using a bobbin, so it is widely used for processing plastic textile products. However, in the production of high-strength heavy-duty woven fabrics, the problem of broken warp yarns on circular looms has seriously affected the production.

Causes of broken warp threads on circular looms:

1. Low warp strength

2. The ambient temperature or humidity is too low

3, the position of the advancing wheel is incorrect or the operation is not flexible

4, the shuttle tail wheel does not rotate flexibly

5, the small shuttle wheel is not clean

6. ​​There are burrs or defects in the thread passing through the shuttle

7, the shuttle propeller box is damaged

8. The shuttle arm is severely worn

9, the wire tube collapses or hangs the wire

Under normal circumstances, the following solutions are recommended:

1, improve the strength of the silk

2, increase the ambient temperature or humidity

3. Adjust the position of the advancing wheel or check the reason for inflexible operation

4. Clean or replace the bearing

5. Clean the small shuttle wheel

6. ​​Check and polish the burrs or deficiencies in the thread passing through the shuttle

7, repair the shuttle propeller box wear or replacement

8. Repair or replace the shuttle arm

9. Replace the wire bobbin